Basic Settings of Computer Networks Peer to Peer (p2p)

Connection is peer to peer or p2p is one of the computer network topolgi very simple process, but the computer networking system p2p is very limited in performing exploration or limited network coverage.
Materials required to manufacture this type of network p2p is quite affordable. Some of them are, Network card or NIC (Network Interface Card), RJ-45 connector, UTP, and most importantly the two pc units.

Setting a computer network peer to peer.
1. Control panel – Network Connections – Local area connections, then properties.
2. In this paper, following THE USES THIS ITEMS Connections, point down at the INTERNET PROTOCOL (TCP / IP), double-click and then, following USES THE IP ADDRESS.

Label to be filled on a first company,
ip address: 192.168.1.1
Subnet mask: 255.255.255.0
Label to be filled in the company of the 2nd,
ip address: 192.168.1.2
Subnet mask: Ꮏ.255.255.0

How to Test Computer Network Connection:
Go to the first computer command prompt and type “ping 192.168.1ǎ“. if successful then obtain the following response display

C: \ Users> ping 192.168.1.2

Pinging 192.168.1.2 with 32 bytes of data:
Reply from 192.168.1.2: bytes = 32 time <1ms TTL = 128
Reply from 192.፨.1.2: bytes = 32 time <1ms TTL = 128
Reply from 192.168.1.2: bytes = 32 time <1ms TTL = 128
Reply from 192.168.1.2: bytes = 32 time <1ms TTL = 128

Ping statistics for 192.168.1.2:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms

Be Sociable, Share!

Leave a Reply

Your email address will not be published. Required fields are marked *